precautions while using washing machine

A washing machine thats off kilter can vibrate, rock or walk across the floor during the spin cycle, which can damage the floor or the machine. Balance the washer by turning the legs clockwise to lower it, and counterclockwise to raise it.

Depending on your machine, the lint collector may be located in the agitator tube, which is the center column of most machines, or near the top of the washtub. Keep it clean to help your washer run efficiently .

Leave the washer lid or door open between loads to dry out the unit and keep it smelling fresh. On front loading washers wipe down the rubber seal around the door after doing your laundry.

Read the appliance instruction manual to make sure you use the correct type and amount of detergent for your machine. Too much soap can leave residue on your clothes and cause excess wear and tear on your washer, and high efficiency washers require a special, low sudsing detergent.

Use the appropriate amount of water for the size of the load. Wash heavy or bulky items in small loads since these are harder on the appliance.

Clothes that need just a light cleaning dont need to be washed for as long as dirty clothes, and dont need as much detergent.

such as Silent Feet, under your washing machine to reduce noise and vibration from your washer.

Separate whites, colored fabrics, synthetics,delicates, and woolens.

90Percent of the energy a washing machine uses goes towards heating the water. A 30?C wash could save over a third of the energy you use when compared to washing at higher temperatures.